Midea US-FC70-DS12DSH/C0401E

Service manual for Wash and Dry Combo product
Midea America Company
-------------------------------------------------------------------------------------------------------------------------------------------------------
－
14
－
4. TROUBLE SHOOTING
4.1 Test mode by Control
Note: Before entering the test mode, you should empty the machine so that there is no
water left in the drum. You can run a spin cycle or open the service panel from the front of
the unit to get all water out. Then make sure all parts are in their original position for check
running.
Shut down the machine by pressing the on/off button, Disconnect the plug from the power supply, and
connect the power again. Press the buttons in sequence of Temp-soil-temp-soil, then, the unit enters
test mode, and “t01” displayed.
4.2 Test modes
Test mode list
Code
Function
Code
Function
Code
Function
t01
Model Setting
t06
Water Switch Test
t11
Factory Test Mode
t02
Error Code Review
t07
Water Heater Test
t12
Water inlet valve Test
t03
Software Version
t08
Drying Heater Test
t13
Factory Test Mode
t04
Display Test
t09
Wash Function Test
t14
Factory Test Mode
t05
Pump Test
t10
Spin Function Test
t15
Factory Test Mode
Notes:
1. t01, t03, t11,, t13, t14, t15 can‘t be used for service!
2. To activate the test mode, Press the “Start/Pause” button once.
3. Press the “Start/Pause” button to again to start the function test.
4. When the test mode is operating, press the “on/off” button will stop the test and exit to status for
Test mode selection.