Service Manual_2018-V1.0
16
5. Production fault solving method
5.1 Simple troubleshooting
1. Water is leaking.
Unplug dispenser, remove bottle and replace it.
2. No water is coming from the spout.
Maker sure the bottle is not empty. If empty, replace it .
Make sure to completely depress the pushbutton controls.
3. No ambient or cold water or hot water flows
1. Over consumption of ambient or cold water in short time--------- Just wait a moment, then hot or
cold water is available again
2. No water supply------- Connect plug to socket, turn on heating or cooling switch
4. Dispenser is noisy.
Make sure the dispenser is positioned on a level surface.
5.2 Machine heating failure
Check the related parts of heat tank
To Next Page
Loading...
Need help?
General
