Service Manual_2018-V1.0
20
6. Maintenance---Clean
To avoid accident, cut off the power supply before operation according to the
following instruction.
1. The machine had been disinfected before departed from factory.
Cleaning the dispenser prior to installing a full bottle of water for the first time.
2. Cleaning and draining instruction:
a. Making sure the power switch in the O (off) position and unplug the water dispenser before
cleaning.
b. Turn on all the taps in turn 3 minutes after the water outflow, which completes the internal
pipeline flushing.
c. Place a large bucket beneath the drain outlet. Remove the drain cover and allow water to
drain.
d. After draining, replace the drain cover and you can use the machine.
Attention: The dispenser heats water to a temperature of approximately 85°C. It can cause
severe burns, please operate it carefully.
3. Sanitizing
The machine should be disinfected with the disinfectant separately bought from drugstore or
marketplace according to the instruction manual of the disinfectant and then clean it with water. Generally
this should be done every three months.
4. To remove mineral deposits:
Mix 4 liters water with 200g citric crystals, inject into the machine and make sure the water can
To Next Page
Loading...
Need help?
General
