Midland 200 - Remote Speaker Operation

ENGLISH
7
EXT
ANT
SPKR
+
-
RED
BLK
Presa altoparlante esterno
Connettore antenna Cavo alimentazione
Band selector Emission mode
switch
External speaker jack
EXT
ANT
SPKR
+
-
RED
BLK
EXT
ANT
SPKR
+
-
RED
BLK
EXT
ANT
SPKR
+
-
RED
BLK
RX/TX
led
Mike
connector
Up/Down
buttons
Squelch
RX
TX
SQUELCH ON-OFF/VOLUME
MIC
Channels
display
Volume/Power switchCommutatore
banda
Commutatore
modalità di emissione
Led
RX/TX
Presa
microfono
Tasti Up/Down
(cambio canale)
Squelch
RX
TX
SQUELCH ON-OFF/VOLUME
MIC
Display
canali
Accensione/volume
REMOTE SPEAKER OPERATION
A 8 Ohm speaker, rated at 3-10 watts, should be used for this function. Plug the speaker into the
EXT SPKR jack at the rear of the transceiver. When the external speaker is plugged in, the internal
speaker is disconnected. You can now monitor all incoming signals through your remote speaker.