EasyManua.ls Logo

Midland 248XL - Page 10

Midland 248XL
53 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
FUNCTION AND LOCATION
OF THE CONTROLS
FRONT PANEL
1. Channel selector: it permits the manual channel selection.
2. Microphone jack: insert the mic connector into this jack.
3. Indicator: this meter indicates the receiving signal strength and the
transmitter RF output power.
4. Multifunction backlighted display.
It shows:
a. channel selected number (from 1 up 40) or operative frequency
b. FUNC button activated
c. ESP: reducing noise device activated
d. DW: Dual Watch function activated
e. EMG: indicates channel being used or when the emergency channels
are activated
f. LOCK: keyboard lock function activated
g. SCAN function activated
h. M1-M2-M3-M4-M5: memory channel indicator
i. Indicates the frequency band selected.
j. It appears when the radio transmits in low power (this condition hap-
pens only in certain frequency bands – see the chart at the end of this
manual).
5. AM/FM” Indicator
It indicates the operative mode. FM: red LED; AM: green LED.
6. “RX/TX” Indicator
LED indicating receiving or trasmitting mode. RX: green LED; TX: red LED.
7. “CB/PA Selector
In the “CB” position, the unit operates as a transceiver. You can use the PA
(public address) function only if you connect a speaker to the PA jack (“PA
visualized on the display). In this case the “MIC” knob controls the amplifi-
cation level.
8. FUNC button
With the SCAN button, you can:
visualize the operative frequency (if you keep pressing the button for 3
seconds approx.), or the channel in use;
activate the second functions of the “M” (M1/M5) buttons.
M1 / M2 / M3 / M4 / M5:
Midland 248 XL has the possibility to store and to recall, when necessary, 5
channels previously memorized.
To memorize one channel, follow the procedure herebelow:
A) Select the channel with the appropriate selector or the “UP/DN” but-
tons on the microphone;
B) Push the “FUNC” button: the display will show “F”;
C) Keep pressing the “M1/EMG” button for 3 seconds: you will hear a “BIP
and the display will show “M1”.
To memorize the other preset, repeat these steps and select another
N.K.M5
LOCK
M4/LCR
AM/FM
M3
SCAN
M2
DW
M1
EMG
FUNC
01
3
5
7
9
30
2
3
5
10
0
POWER
MIC
CH
VOL
SQ
MIC
RF
TX RX AM FM
CB/PA
1
2
3 4567
8 9 10 11 12 13 14
16
18
15
17
F
EMGDWESP LOCK SCANLOW
®
Q.UP
M1 M2 M3
M4 DW
EMG
SCAN
Q.DOWN
a
b
ecfdg
i
j
h

Other manuals for Midland 248XL

Related product manuals