Midland BT City - Bluetooth Device Connectivity; Pairing Other Bluetooth Devices; Telephone Feature Usage

6
GPS voice announcement
When the GPS is paired to the “Volume +” button,(high priority) the
street voice announcement will always interrupt the intercom.
When paired using the “Volume -” button, (lower priority) the voice
announcement are always in background also if the intercom is active.
AUX wired connection
Music or audio from the AUX wired connection, by default it is always
in the background also when the intercom is open or during a phone
call. It is possible to change this beaver following the procedure de-
scribed in the “Setup and Special conguration” chapter.
Pairing to other Bluetooth devices
The BTCity unit can be paired to other Bluetooth devices, like Phone,
GPS Navigator or PMR446 Radio with built-in or external Bluetooth.
The pairing procedure must be done using the “Volume +” or the
“Volume -“ buttons.
› Pairing to the “Volume +” button: for Phone with music
(A2DP stereo).
› Pairing to the “Volume -” button: for GPS navigators and other
devices which the audio must be always in background.
Attention: The “Volume -” button does not support the pairing with a
phone and do not support A2DP Stereo Music.
Using the telephone features
The cellular phone can be paired only to the “Volume +”, in this way
it is possible to manage all the phone functionalities and listen to the
stereo music. An incoming call has the higher priority, that means all
other communications will be closed (Intercom, Music).
Pairing the unit with a mobile phone
1. Enable the Bluetooth device search feature on your mobile phone.
As this procedure varies according to the brand and model of the
mobile phone, refer to the manual supplied to your particular pho-
ne for further information.
2. Press and hold down the middle button about 7 sec., until the Red
light is on permanently (setup mode). Now press for 3 seconds the
“Volume +” button, the Blue and Red light will ash.
3. After a few seconds the mobile phone will display “Midland BTCi-
ty”. Select it and follow the instructions provided in your mobile
phone manual to accept the pairing. When prompted, enter the
pairing code, which is 0000 (four zeroes). Your mobile phone
should then display a conrmation message if the pairing opera-
tion has been successfully completed
4. The BTCity will automatically exit the set up mode (red indicator
on) and go to the working mode (blue light ashing).
Answering a call
When you hear the phone ring, you can answer in two dierent ways:
Vocally:
Simply say one word to answer the call and start talking.
Manually:
Tap the “Control” button and start speaking.
Rejecting a call
If you don’t wish to answer, you can let the mobile phone ring or press
the “Control” button for 3 seconds (you will hear one audio conrma-
tion tone).
› GPS
› PMR446 Radio
› Phone (GPS)