UK
24 www.midlandeurope.com
Step 3.Then, tighten more the two screws in order to firmly fix the clamp in place on the
left side of the helmet.
If neccesary, you can use also the rubber plate in order to have more grip for the screw
clamp. Just use the two short screw to fix the rubber plate on the slide-in mount and
tighten the screw plate again.
Fitting and removing your Midland BTNEXT PRO
The BTNEXT PRO can be easily fitted onto the helmet by sliding it downwards on the
sliding mounting kit. BTNEXT PRO is maintained in position thanks to the fixing clip
located on the upper section (A).
To detach the BTNEXT PRO, simply press the fixing clip and push the unit upwards.
A
UnlockLock
Switching ON and OFF your Midland BTNEXT PRO
Switching the unit on:
Press and hold “Middle” button for approximately 3 seconds until the BLUE indicator
lights.
Switching the unit o:
Press and hold both “Middle” and “Backward” buttons together for approximately 3 se-
Here is an example of the buttons main functionality based on the mode you are on.
Mode Forward (Left button) Middle button Rear (Right button)
Intercom Open/close the intercom to the first rider Open/close the intercom to the second rider Open/close the intercom to the Third rider
Phone
Redial last number/accept or reject incoming call on
“Vol+”
Redial last number/accept or reject incom
-
ing call on “Vol-”
Phone (while music play) Forward the song Play/pause Backward the song
FM Radio Scan up FM Radio On/o Scan down
Rubber Plate
To Next Page
Loading...
Need help?
General
