- 13 -
I) CUTTING HEIGHT ADJUSTMENT LEVER
This lever serves to adjust the cutting height. Warning: if the cutting height is set too low
the following undesirable consequences may occur:
- foreign objects such as stones, etc., may be thrown outwards
- dirt and mud may accumulate inside the rotor guard, thus impeding regular discharge
of cut grass.
- premature flail wear and possible breakage of the same.
L) HANDLEBAR ADJUSTMENT LEVER
The height of the handlebars can be adjusted to suit both the user and the working
conditions. Set the handlebars at user hip height.
M) ON SWITCH
Two-position switch:
(1) for starting the engine
(0) for switching off the engine
N) SPEED SELECTOR LEVER
This lever is used to select the forward speed of the machine.
The numbered positions indicate the speed settings (1st - 2nd) and the letter N indicates
the neutral gear.
O) GEAR LEVER
This lever is used to select the advance of the machine (forward, neutral, reverse). Used
together with the speed selector lever (Fig.2 Ref. N) it gives 2 forward gears and 2 reverse
gears.
WARNING
Before operating the gear lever ( Fig. 2 Ref. O) it is advisable to set the speed selector
lever (Fig. 2 Ref. N) in neutral (N). The required gear should only be selected after this
operation.
WARNING
Be sure to set the lever positions correctly (Fig. 2 Ref. N and O), making sure that the
levers are correctly engaged; if they are not engage the forward clutch mo-mentarily (Fig.
1 Ref. A) so that the speed setting engages correctly.
The above operation may prove particularly useful during the machine's first working hours.
To Next Page
Loading...