Midland FLM60H - Cutting Tips; Checks; Tyre Pressure Check

- 23 -
B) CABLE CONTROL ADJUSTMENT
To adjust the cables place the machine on flat ground, switch off the engine and disconnect
the wire from the spark plug.
Figure 5
B1) RIGHT AND LEFT WHEEL RELEASE CABLES ( Fig. 5 Ref. A)
Inspect or move the cable sheathing slightly to ensure play of 1-2 mm between the upper part
of the cable and the adjustment screw (Fig. 5. Ref. A, ). If there is none, restore to ideal
position using the relative adjustment screw. The above drawing shows the cable of the left
lever. Of course, the same operation should also be performed for the right wheel release
lever.