Midland G13 - VOX (Hands-Free); VOXTIM (Vox Delay Times); Squelch (SQ)

Midland G13 instruction guide | 9
VOX
The VOX feature enables hands free conversations without using PTT: just speak
in the direction of the microphone and the communication will be automatically
activated.
The VOX sensitivity can be adjusted in 10 dierent levels (0,1,2,3…9) through the
Menu or programming software :
OFF means that the VOX is turned o, level 9 has the lowest VOX sensitivity, 1is
the highest one.
To activate the VOX levels:
1. Press MENU;
2. Rotate the Encoder knob till the display shows
VOX ;
3. Enter the function by pushing the ENT key;
4. Rotate the encoder knob again to select the desired VOX level:
9= lowest sensitivity; 1= highest sensitivity.
5. Confirm your selection by pushing ENT;
6. Push BACK to exit the menu.
VOXTIM (Vox Delay Times)
This function allows to set a delay at the end of hands-free (VOX) transmission to
let people finish their conversation before returning to rx mode.
1. Press MENU;
2. Rotate the encoder until the display shows
VOXTIM ;
3. Press ENT to enter the function;
4. Rotate the encoder again to set the desired delay time (from 0.5 to 3 se-
conds);
5. To confirm press ENT;
6. Press BACK to exit the MENU.
Squelch (SQ)
The Squelch function suppresses noises on free channels and allows to receive even
weak signals.
G13 has 10 (0-9) dierent Squelch levels that can be set by programming software
or Menu:
0 means that the Squelch is turned o; from level 1 to level 9 you will have dierent
levels of noise reduction. The higher is the level, the louder will be the Squelch.
By default, the Squelch level is set on level 5.
To select the Squelch level:
1. Press the MENU button;
2. Turn the Encoder knob until
SQ is displayed;