14 | Midland G18 PRO instruction guide Midland G18 PRO instruction guide | 15
If you want to use and select a DCS code, instead of a CTCSS tone, follow these steps:
1. Press the MENU button;
2. Turn the Encoder knob till: “C-CDC”(in TX and RX); “R-CDC”(only in RX) or
“T-CDC” (only in TX) appears on the display;
3. Push ENT to enter the function;
4. Press the Function key 1;
5. Turn the Encoder knob and select the desired DCS code;
6. Confirm the selection by pressing the ENT button.
The setting of a DCS code disables all CTCSS tones, because these functions cannot be
used simultaneously.
Name - Nome
It is possible to choose and set a name that will appear on the display instead of the
channel number.
Technical specifications
GENERAL
Frequency range 446.00625- 446.19375 MHz (PMR446)
Channels 16+83 pre-set
Working temperature -20°+55°
Operating voltage 7.4V
Operative Mode Simplex
Dimensions 113mm×56mm×38mm (Antenna excluded)
Weight 240g (Battery included)
Impedance Antenna 50Ω
Duty cycle 5/5/90%
TRANSMITTER
Frequency stability ±2.5PPM
Output power ≤500mW ERP
Max frequency deviation ≤2,5KHz
Audio distortion ≤3%
Adjacent channel power < 60 dB
Spurious radiation Within European legal terms
Occupied bandwidth Within European legal terms
RECEIVER
RF sensitivity <0.2UV@20 dB SINAD
Audio distortion ≤3%
Audio response 300Hz ÷ 3KHz
Adjacent channel selectivity Within European legal terms
Intermodulation rejection Within European legal terms
Spurious emissions Within European legal terms
Blocking Within European legal terms
SAR 0,982W/Kg
WARNING: Direct plug-in ac/dc power supply must be used for disconnecting the tran-
sceiver from the mains; the desktop charger must be positioned close to the unit and
easily accessible.
To Next Page
Loading...
