Model GXT2000/2050 Series
Page 8 www.midlandusa.com
To ensure you get maximum range:
l Be sure to use fresh or fully charged batteries - low batteries will
cause low power conditions.
l Be sure you are on a GMRS channel - FRS channels are restricted
by the FCC to low power.
l Be sure to set your radio to use Hi power.
GXT2000/2050 SERIES QUICK REFERENCE CHART
MONITOR
Pressing and holding the MONITOR button for 3 seconds will let
you hear noise so you can adjust the volume level of the radio when
not receiving a signal. This should be used to check activity on your
current channel before transmitting. Press and hold the MONITOR
button for 3 seconds again to get out of MONITOR mode.
SCAN
Your GXT2000/2050 Series can scan all 50 channels for activity. To
enter, quickly press the SCAN button. Repeat the same procedure
to exit. Your radio will rapidly scan each of the 50 channels and stop
on any active channel. Your radio will resume scanning after 4 sec-
onds when the channel is no longer active.
When you press the PTT button to transmit on an active channel,
the scanning function will stop and remain on the active channel
for 10 seconds before resuming scan when PTT button is no longer
pressed.
To resume scanning, quickly press the