Model ALR2 Series
Page 5
midlandusa.com
BATTER
Y INSTALLATION
Your radio operates with either 3 AAA NiMH batteries or optional 3
AAA alkaline batteries. The belt clip should be removed (see below)
to ease installation or removal of the batteries.
To install the batteries:
1. With the back of the radio facing you, remove the belt clip (see
diagram below) for easy access, then remove the Battery Cover by
pressing down on the top center and sliding it down from the radio.
2. Insert 3 AAA NiMH batteries or 3 AAA batteries observing the
polarity as shown. Installing the batteries incorrectly will prevent
the unit from operating or may damage the unit.
3. Return the Battery Cover by sliding it up on the radio. Replace the
belt clip, making sure it locks into place.
INSTALLING THE BELT CLIP
To install the BELT CLIP, slide the clip down into the slot on the back
of the radio until the BELT CLIP LATCH clicks. To remove the BELT
CLIP, pull the LOCK TAB away from the radio, then gently pull the
belt clip up toward the top of the radio.
To Next Page
Loading...
Need help?
General
