Midmark Preva - Page 70

System Configuration
Preva
63
System Configuration
System Configuration Mode
About System
Configuration
Mode
The Preva Dental X-ray System has a software-driven system configuration
mode. When the Preva is in system configuration mode, you can perform the
following procedures:
 Adjusting the Display
 Changing the Pre-programmed Exposure Settings
 Change the Cone Size
 Showing the Current System Configuration
 Display Diagnostic Data
Using System
Configuration
Mode
1. To enter system configuration mode, press the Tooth Selection and Patient
Size Selection buttons on the Operator Panel simultaneously for 5
seconds. The display shows the Main System Configuration menu, as
shown in Figure 49, and the Ready Indicator blinks.
2. To select menu items while in system configuration mode, use the up and
down arrows to highlight a menu option. Then use the right arrow button as
an “Enter” button to select the highlighted option. When changing presets,
the right arrow button is also used to select the technique factor.
3. After selecting a menu option, use the up and down arrows to increase or
decrease values.
Figure 49
Main System
Configuration Menu