Midtronics WALMART GR8-1150

5:/057
0LWL,06WWL,
LWL

WWDFKlWKHKDUHUDEOHV
The two connectors for the charger cables are located on
the back of the Battery Diagnostic Station. Three screws are
included to secure the cables. To attach the cables:
1. Plug in the large connector (A), then plug in the small con-
nector (B).
2. Slide the cover (C) down the cables until it seats against
the sheet metal.
3. Insert the screws (circles) through the holes in the cover
and sheet metal. Tighten the screws securely with a small
screwdriver. (To remove the cables, use the attachment in-
structions in reverse.)
KDSWHU%HIRUHRX%HL
$
%
