TROUBLESHOOTING
l Before servicing electronics, turn off AC power to the VGM. Wait for capacitors to discharge.
l Before touching or handling electronic assemblies, discharge static electricity on your body. To dis-
charge static, begin by connecting the line cord to a properly grounded outlet, but do not turn on the
power! Next, touch the safety ground stud of the power supply chassis.
l Store electronic assemblies in an anti-static area. Use anti-static bags to store or transport circuit
boards, Transport the hard drive in original shipping container.
l Do not remove or connect electronic assemblies when the power to the cabinet is switched on. Other-
wise you’ll damage electronic assemblies and void the warranty.
l Replace ground wires, shields, safety covers, etc., upon completion of maintenance or service. install
and firmly tighten all ground and mounting screws.
ARCTIC THUNDER
To Next Page
Loading...
