Switching on
Switch the master switch on the
left-hand side of the machine to the "I"
position.
^
Touch the On/Off sensor -.
The appliance will begin rinsing after
the heating-up phase. Hot water will
come out of the central spout.
If the coffee machine still has an
operating temperature which is
higher than 60 °C, rinsing will not
take place.
When "Select drink" appears in the
display, you can prepare drinks.
If you do not touch any sensors or
run the maintenance programme, the
display will switch itself off after
approx. 7 minutes to save energy.
The right-hand LED will flash on and
off as long as the machine is
switched on.
Touch any one of the sensors to
wake the machine up again to make
a drink.
Switching off
^
Touch the On/Off sensor -.
After a coffee has been dispensed, the
pipework will be rinsed before the
machine switches off.
If a drink has been made using milk,
the message "Place milk pipework in
drip tray" will appear in the display.
Insert the end of the milk pipe into the
aperture in the drip tray, then
^
touch OK.
If the milk system is not rinsed out
before switching off, it will have to be
rinsed the next time the machine is
switched on.
Switching off for longer
periods of time
If the coffee machine is not going to be
used for a longer period of time, e.g.
whilst on holiday:
^
Empty the drip tray, the waste
container and the water container.
^
Clean all parts thoroughly, including
the brew unit.
^
Switch the machine off with the
master switch and at the wall socket.
The time of day will not be saved. It will
have to be reset next time the machine
is switched on.
Switching the coffee machine on and off
22
To Next Page
Loading...
