Miele CM 6300 - Appliance Rinsing Procedures

,
Danger of burning and scalding
on hot components or by hot liquids.
Always allow the coffee machine to
cool down before cleaning it.
Caution: Water in the drip tray can
be very hot.
Do not use a steam cleaner to clean
the coffee machine. Steam could
reach the electrical components
and cause a short circuit.
To avoid damaging the surfaces of
your appliance, do not use:
– cleaning agents containing soda,
ammonia, acids or chlorides,
– solvent-based cleaning agents,
– cleaning agents containing
descaling agents,
– stainless steel cleaning agents,
– dishwasher cleaner,
–
glass cleaning agents,
–
oven cleaner,
–
abrasive cleaning agents, e.g.
powder cleaners and cream
cleaners,
–
hard, abrasive sponges, e.g. pot
scourers, brushes or sponges which
have been previously used with
abrasive cleaning agents,
–
dirt erasers,
–
sharp metal tools.
Rinsing the appliance
After a coffee has been dispensed, the
machine is rinsed before it switches off.
This removes any residual coffee
grounds.
You can also rinse the appliance
manually.
^
Touch x.
^
Touch the Y arrow sensor repeatedly
until "Maintenance" is highlighted.
Then touch OK.
^
Select "Rinse appliance" and touch
OK.
The pipework will now be cleaned.
You may also be prompted to insert the
end of the milk pipe into the drip tray.
Cleaning and care
47