If you cannot remove the brew unit or
can only do so with difficulty, the brew
unit is not in the correct position (See
"Problem solving guide").
Do not change the position of the
brew unit handle, as this would
cause the brew unit to be out of
alignment and you will not be able to
push it back into the coffee
machine.
^
Clean the brew unit by hand under
warm running water without using
washing-up liquid.
^
Wipe any remaining coffee off the two
filters. One filter is located in the
funnel and the other to the left of the
funnel.
^
Dry the funnel to prevent ground
coffee sticking to it the next time a
coffee is prepared.
^
Clean the inside of the coffee
machine. Use your vacuum cleaner
to remove dry coffee grounds.
To replace the brew unit, proceed in
the reverse order:
^
Push the brew unit back into the
coffee machine, making sure it is
straight.
^ Press the button under the handle of
the brew unit a and, whilst doing so,
turn the handle to the right b.
^ Close the appliance door.
Cleaning and care
55
To Next Page
Loading...
