Problem solving guide
90
Problem Cause and remedy
F73 or
Check the brew unit
The brew unit cannot be positioned correctly.
Switch the machine off with the On/Off sensor.
Remove the brew unit and clean it by hand.
Push the coffee ejector of the brew unit into the
correct position.
Do not fit the brew unit. Close the service panel
and switch the coffee machine on with the On/
Off sensor.
This will initialise the brew unit motor and put it back
into the start position.
When Insert the brew unit appears in the display, put
the brew unit back in the machine. Close the
appliance door.
If the message appears again, reduce the amount of
coffee and/or select a finer grinder setting. Some
types of coffee have a much higher grinding volume.
To Next Page
Loading...
