Unpacking and installing
20
Unpacking the coffee machine
Unpack the coffee machine.
Remove any protective foil and notes
from the machine.
Tip: Please retain the original box and
polystyrene pieces so that you can
pack the machine securely, should you
need to transport it in the future.
The drip tray cover can be found in the
accessories pack.
Remove the protective foil from the
drip tray cover and place the drip tray
cover into the lower panel.
Accessories supplied
The following accessories are included
with your coffee machine:
– Stainless steel milk flask MB CM
(capacity 0.5l)
– Milk pipework (suitable for use with
the milk flask and with milk cartons or
similar)
– Cleaning tablets for degreasing the
brew unit (starter set)
– Miele descaling tablets (starter set)
– Miele descaling cartridge
– Cleaning brush
Setting up and connecting the
coffee machine
Danger of overheating due to
insufficient ventilation.
If the coffee machine is not
sufficiently ventilated, the appliance
can overheat.
Please ensure that there is adequate
ventilation around the coffee
machine.
Do not cover the coffee machine
with tea towels etc. while it is in use.
If the coffee machine is installed in a
niche, heat and moisture will
accumulate inside the niche. This
can result in damage to the coffee
machine and/or furniture unit.
Do not install the appliance in a
niche.
Please observe the following installation
instructions:
– The location of the machine must be
dry and well ventilated.
– The ambient temperature of the room
in which the machine is used must be
between 16°C and 38°C.
– Do not place the coffee machine near
a window in direct sunshine or right
next to an appliance that gives off
heat. These would subject the
machine to ambient temperatures
outside its permitted operating range.
– The coffee machine must be set up
on a level surface. The surface must
be water resistant.
To Next Page
Loading...
