Problem solving guide
94
Problem Cause and remedy
Fill and refit the water
container appears after
switching on even
though the container is
filled and fitted in the
machine. The appliance
does not rinse.
The descaling cartridge is not fitted. The coffee
machine needs descaling.
Switch the machine off with the On/Off sensor.
Wait approx. one hour.
Switch the appliance back on again. As soon as
Heating-up phase appears, touch Mainten. and then
select Descale the machine.
Descale the coffee machine.
Insert the drip tray and the
waste container appears
in the display, even
though both have been
inserted.
Although the drip tray
has been emptied,
Empty the drip tray and the
waste container appears
in the display.
The drip tray is not in the correct position and is
therefore not detected.
Empty the drip tray and the waste container if
necessary.
Reassemble all parts and push the drip tray back
in the coffee machine until it clicks.
The waste container is
full, although the drip
tray and waste
container have been
emptied following each
reminder.
This is not a fault.
The drip tray has probably been removed without the
waste container being emptied.
Removing the drip tray resets the internal counter for
emptying the waste container.
Always empty the waste container if you remove
the drip tray.
To Next Page
Loading...
