Cleaning and care
55
Twist upper section with the holder
for the milk pipework and pull it off.
Then pull the Y-shaped piece off.
Release the spout nozzles.
Clean all parts thoroughly.
Clean the surfaces of the central
spout with a damp cloth.
If the milk pipework is blocked, clean it
under running water with the brush sup-
plied.
Insert the brush in the tube and move
it back and forth as far as it will go
until all milk residue has been re-
moved.
Fit the dispensing unit back together.
Push the dispensing unit back onto
the central spout. Press firmly to en-
sure the spouts at the bottom con-
nect correctly with the edge of the
dispenser.
Replace the stainless steel cover and
connect the milk pipework if applic-
able.
To Next Page
Loading...
