EasyManuals Logo

Miele Complete C2 Flex User Manual

Miele Complete C2 Flex
Go to English
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
en
42
a AirClean
Replace this filter every time you start a
new packet of Miele dustbags. Every
packet of original Miele dustbags con-
tains one AirCleanexhaust filter. Mul-
tipacks contain four AirCleanfilters.
bAirClean Plus 50 (light blue)
Replace this filter after approx. one
year. Make a note of the date on the ex-
haust filter.
cActive AirClean50 (black)
dHEPA AirClean50 (white)
Replace this filter when the timestrip®
filter change indicator is completely red
(Fig. 14). The indicator lights up after
approximately 50hours of operation,
which is equivalent to about a year of
average use. You can continue vacuum-
ing when the light comes on. However,
the suction power will be reduced as
will the effectiveness of the filter if it is
not replaced in good time.
Replacing the AirClean exhaust
filter(Fig. 33 + 34)
Do not use more than one exhaust
filter at a time.
Open the dust compartment lid.
Open the filter grille.
Grasp the used AirCleanexhaust filter
by the clean, unsoiled section and
take it out.
Replace it with a new AirCleanex-
haust filter.
If you wish to fit an AirClean Plus50,
Active AirClean50 or HEPA
AirClean50exhaust filter, see “Repla-
cing one type of exhaust filter with an-
other”.
Close the filter grille.
Close the dust compartment lid.
Replacing the AirClean Plus50,
Active AirClean50 and
HEPA AirClean 50 exhaust filters
(Fig. 35 + 36)
Do not use more than one exhaust
filter at a time.
Open the dust compartment lid.
Lift the exhaust filter and remove it.
Insert a new exhaust filter, making
sure it goes in properly, then press it
down into position.
If you are using exhaust filter c or d,
press the timestrip® filter change in-
dicator(Fig. 12).
After approx. 10–15seconds, a thin red
line will appear in the left-hand side of
the display (Fig. 13).
If you wish to fit an AirCleanexhaust
filter, see “Replacing one type of ex-
haust filter with another”.
Close the dust compartment lid.
Replacing one type of exhaust filter
with another (Fig. 09)
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miele Complete C2 Flex and is the answer not in the manual?

Miele Complete C2 Flex Specifications

General IconGeneral
Vacuum brushes includedUniversal brush
Upholstery nozzle includedYes
Power sourceAC
AC input voltage220-230 V
Maximum input power890 W
Annual energy consumption22.7 kWh
TypeCylinder vacuum
Hose length2 m
Cleaning typeDry
Dust capacity4.5 L
Product colorBlack
Dust container typeDust bag
Proper useHome
Noise level80 dB
Cleaning surfacesBare floor, Carpet, Hard floor, Stair steps, Upholstery
Vacuum air filteringAir-clean
Dirt separating methodFiltering
Cord length6.5 m
Weight and Dimensions IconWeight and Dimensions
Depth275 mm
Width487 mm
Height227 mm
Weight6900 g
Package width590 mm
Package height380 mm
Package weight9600 g

Related product manuals