en
57
Problem solving guide
Many malfunctions and faults that can occur in daily operation can be easily
remedied. You can save time and money in many cases, as you do not need to call
the Miele Customer Service Department.
Information to help you rectify faults yourself can be found at www.miele.com/ser-
vice.
The following tables are designed to help you to find the cause of a malfunction or a
fault and to resolve it.
Problem Cause and remedy
The vacuum cleaner
switches off automatic-
ally.
On certain models, the
overheating protection
warning light also
comes on.
A temperature limiter switches the vacuum cleaner off
automatically if it gets too hot.
This can occur if, for instance, large articles block the
suction tube or when the dustbag is full or contains
particles of fine dust. A heavily soiled motor protec-
tion or exhaust filter can also be the cause of over-
heating.
Switch the vacuum cleaner off immediately using
the On/Off footswitch. Switch off at the wall
socket and unplug it.
After removing the cause, wait for approximately 20–
30 minutes to allow the vacuum cleaner to cool down.
It can then be switched on again.
Technical data
(for models with radio controlled handle)
Frequency band 433.05 MHz – 434.79 MHz
Maximum transmitting power <10µW
To Next Page
Loading...
Need help?
General
