Cleaning and care
24
Stainless steel frame/control
panel
Clean the frame and the control panel
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
You can also use a ceramic and stain-
less steel cleaning agent. We recom-
mend also using a stainless steel condi-
tioning agent to help prevent resoiling
(see "Optional accessories).
Do not use ceramic and stainless
steel cleaner or stainless steel condi-
tioning agent on the printing.
This would rub the printing off.
These areas should be only cleaned
with a solution of warm water and a
little washing-up liquid applied with a
soft sponge.
Operating controls
Clean the control(s) with a solution of
warm water and a little washing-up li-
quid applied with a soft sponge.
Stubborn soiling should be soaked
first.
Dry the control(s) with a clean cloth.
Rack and lava rock container
Clean the rack after use using hot
water and a little washing-up liquid. If
the rack is heavily soiled, soak it and
then remove the soiling with a brush.
After that, let the rack dry thoroughly.
Then dry the rack and the lava rock
container.
If the lava rock container is heavily
soiled a non-abrasive stainless steel
spiral pad can be used together with a
little stainless steel cleaning agent (see
"Optional accessories").
Do not use conditioning agent for
stainless steel in the lava rock con-
tainer.
To Next Page
Loading...
