7. Venting
Air extraction mode
^
Complete the venting installation, see
"Air extraction".
Recirculation mode
If the hood cannot be installed for air
extraction the appliance must be
connected for recirculation mode.
For recirculation mode a respective
installation kit is recommended which
can be obtained from Miele.
In addition an active charcoal filter is
needed.
^
The non-return flap is not needed for
the recirculation mode. Pull the
non-return flap off the bracket from
the vent connection.
^ Install the installation kit as described
in the manual supplied with the kit.
^
Make sure that the slats in the grill
point towards the center of the room
and not towards a wall or the ceiling.
^
Install the Active Charcoal Filter (see
"Cleaning and care").
8. Electrical connection
Refer to the notes in "Electrical
connection" and "Important Safety
Instructions" before connecting to
the mains.
^
Plug in the power cord.
Installation
33
To Next Page
Loading...
