Recirculation mode
If site conditions are not suitable for the
hood to be used for air extraction, the
appliance must be converted for
recirculation using the following
installation kit. It can be ordered from
your Miele dealer or the Technical
Service Dept.
It contains a 6" (150 mm) diameter
hose, a grille and a hose clamp to
secure the hose at the exhaust
connection of the hood.
DA 2280 installation needs
one installation kit and two active
charcoal filters
DA 2210 installation needs
two installation kits and four active
charcoal filters
A non-return flap is not needed in
recirculation mode.
^
Install the installation kit according to
the installation situation.
When installing the recirculation
vents make sure that the slats point
towards the center of the room and
not to a wall or the ceiling.
^
Install the active charcoal filters (see
"Cleaning and Care") and reprogram
the charcoal filter timer.
Installation
30
To Next Page
Loading...
