Miele DAD 4840 - Initial Setup and Configuration; Selecting Operating Mode

Before using for the first time
17
Selecting extraction mode or
recirculation mode
The cooker hood is suitable for both
extraction mode and recirculation
mode. The power of the fan is
adapted to suit the selected operating
mode. The cooker hood is delivered
set up for recirculation mode. It has to
be reset for extraction mode.
To reset it for extraction mode, the
operating hours counter for the
charcoal filter(s) has to be deactivated.
 With the deflector plate retracted,
touch the On/Off switch.
All symbols light up with reduced
brightness.
 Press and hold the run-on option
control until the grease filter
and charcoal filtersymbols light
up.
 Touch the charcoal filter symbol.
The charcoal filter symbol and one of
the fan power levels will flash.
 Touch B.
 Confirm your choice by touching the
charcoal filter control.
All the indicator lights will go out.
Extraction mode has now been set.
If you do not confirm your selection
within 4minutes, the cooker hood will
automatically revert to the original
setting.
Activating/Deactivating
Plug&Play
 Touch the On/Off switch.
All symbols light up with reduced
brightness.
 Press and hold the run-on option
control.
After a few seconds, the grease filter
and charcoal filter symbols light up,
and after a further 5seconds the 1 fan
power level indicator lights up.
The deflector plate extends.
 Then touch the following controls in
turn:
- 1
- The lighting control and
- The lighting control again
When Plug&Play is deactivated, the
indicators 1 and 3 will flash.
When Plug&Play is activated, the
indicators 1 and 3 will light up
constantly.
 To activate, touchB.
The 1 and 3 indicators light up
constantly.
 Touch 1 to deactivate.
The 1 and 3 indicators flash.
 Confirm the setting with the run-on
option control.
All the lights will go out.
If you do not confirm your choice of
setting within 4minutes, the cooker
hood will revert to the old setting.