Operation (Manual mode)
28
- If you touch the run-on option
control again, the fan will remain
on ( will go out).
Switching the fan off
Touching the control for the active
power level again switches the fan
off.
The deflector plate remains extended.
Run-on in Plug&Play operation
If you switch off the fan in Plug&Play
mode, it will run on at level1.
Run-on ensures that the plinth is
ventilated after cooking.
Depending on the last active fan level,
run-on lasts between 2 and 30minutes.
You can switch off the fan immediately
during run-on by pressing 1 or the On/
Off switch.
This function is independent of the run-
on function.
Switching on and dimming the
hob lighting
The hob lighting can be switched on
and off and dimmed independently of
the fan.
With the deflector plate retracted,
touch the On/Off switch.
All symbols light up with reduced
brightness.
Touch the lighting control briefly.
The deflector plate extends.
The lighting will switch on at maximum
brightness. All 3 bars next to the
lighting control light up.
With the lighting switched on, press
and hold the lighting control. The
brightness will gradually dim until you
release the control.
Press and hold the lighting control
again to increase the brightness to
the level required and then release it.
Alternatively, you can select 3
brightness levels by touching the bars
next to the lighting control.
Switching the hob lighting off
Touching the lighting control again
switches the hob lighting off.
The deflector plate remains extended.
To Next Page
Loading...
