Operation
26
Open the drawer and the glass lid.
Place vacuum adapter over the va-
cuum pump air intake valve.
Attach the connector to the con-
tainer lid. Make sure that the closure
of the lid is turned to "seal" (closed).
Switch the drawer on with the
sensor.
The and sensors will light up.
Touch the sensor.
The and sensors go out. The
and sensors light up.
Touch the sensor repeatedly until
the segment for the required vacuum
level lights up.
Touch the sensor.
The vacuuming process will start.
Leave the glass lid open for the en-
tire duration of the vacuuming pro-
cess.
If an excessive amount of bubbles
form you can cancel the vacuuming
process by pressing the sensor
(see "Cancelling the vacuuming pro-
cess").
After the vacuuming process
An acoustic tone will sound.
Dettach the connector from the con-
tainer lid. Make sure that the closure
of the lid is still turned to
"seal" (closed).
Remove the vacuum adapter from the
vacuum pump air intake valve.
Before starting a new vacuuming
process, check that the vacuum ad-
apter, the tube and the vacuum
chamber are clean and dry.
Remove any soiling or liquid residues
if necessary.
To Next Page
Loading...
