Operation
27
After use
Touch the sensor to switch the
drawer off.
Clean and dry the drawer and any ac-
cessories as described in "Cleaning
and care".
Do not close the glass lid until the va-
cuum chamber is completely dry.
Close the drawer.
The last vacuum and sealing level se-
lected is automatically activated the
next time the drawer is switched on,
and this is shown in the display.
Cancelling a vacuuming pro-
cess
You can cancel a vacuuming process at
any time, e.g. if you notice during the
process that the edge of the bag is not
positioned correctly or that the closure
on the container lid is not pointing to
"seal" (closed).
Please note that when vacuuming
bags, if the vacuuming process is
cancelled, the bag will not be sealed.
Touch the sensor.
The vacuum process stops.
To Next Page
Loading...
