Miele EVS 6214 - Vacuuming Cancelled; Lid Wont Open

ImportAppliances.com
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
Problem solving guide
35
Problem Cause and remedy
There is a film of oil on
the glass lid and in the
drawer.
The oil in the vacuum pump has become extremely
hot.
 Clean the drawer and leave it to cool down for
1hour before starting another vacuuming process.
 When carrying out a number of consecutive vacu-
uming processes, wait a minimum of 2minutes
between each process to prevent the oil from
overheating again.
 If the problem occurs again, contact the Miele Ser-
vice Department.
The vacuuming process
is cancelled after
2minutes. An acoustic
tone sounds and the
symbol lights up red.
The required vacuum could not be achieved.
 Switch the drawer off and back on again.
 Start the vacuuming process again, selecting a dif-
ferent vacuum level if necessary.
After intensive use of the drawer the oil in the vacuum
pump has severely overheated.
 Leave the drawer to cool for an hour before start-
ing another vacuuming process.
 When carrying out a number of consecutive vacu-
uming processes, wait a minimum of 2minutes
between each process to prevent the oil from
overheating again.
The vacuuming process
is cancelled after
5seconds. An acoustic
tone sounds and the
symbol lights up red.
The glass lid is not sitting evenly. There is an object,
e.g. the edge of a bag, or some soiling on the surface
of the chamber seal.
 Remove the obstruction and/or the soiling.
 Close the glass lid and press it down lightly for ap-
prox. 5seconds.
The chamber seal is not fitted correctly.
 Press the chamber seal in all the way round to
make sure it is fitted evenly.
The chamber seal is damaged, e.g. cracks can be
seen.
 Call the Miele Service Department to replace it.