Switching on and off
19
Before using for the first time
Packaging material
Remove all packaging material from
the inside of the appliance.
Cleaning
Please refer to the relevant instruc-
tions in “Cleaning and care”.
Clean the inside of the appliance and
the accessories.
Switching the refrigeration ap-
pliance on
To enable the temperature to get suffi-
ciently cold inside the refrigeration ap-
pliance, allow it to run for a few hours
before placing food in it for the first
time. Do not place food in the refriger-
ation appliance until it has reached the
required coldness (at least -18°C).
Press the button.
The refrigeration appliance will start
cooling. The temperature display and
the alarm symbol will flash until the
freezer is cold enough to use.
Switching off
Press the button until the display
goes out.
If this does not work, the safety lock is
activated (see “Selecting further set-
tings – Activating and deactivating the
safety lock”).
The cooling system will be switched off.
Switching off for longer peri-
ods of time
If, during a long absence, the refri-
geration appliance is switched off
but not cleaned and the door(s) left
shut, there is a risk of mould forming
inside the appliance.
It is essential to clean the refrigera-
tion appliance.
If the refrigeration appliance is not go-
ing to be used for a longer period of
time, observe the following:
Switch the refrigeration appliance off.
Switch off at the wall socket and
withdraw the plug from the socket, or
disconnect the fuse.
Defrost the freezer.
Clean the refrigeration appliance and
leave the door ajar to air the appli-
ance and avoid odours building up in-
side.
To Next Page
Loading...
