Installation
*INSTALLATION*
63
Whilst counterholding adjusting
bolts with a screwdriver, tighten
nuts on the appliance door with
screwdriver.
Attach the appliance door and the
furniture door using screws through
fixing brackets:
- Drill holes in the furniture door (mark
the position of the holes first).
- Screw in the short chipboard
screws (4x14mm).
Align the furniture door along the
depth plane Z: loosen the screws in
the long slots at the top of the appli-
ance door as well as under the ap-
pliance door. By moving the fur-
niture door, create a gap of 2mm
between the furniture door and the
front edge of the niche. Align accord-
ing to the adjacent furniture doors.
Close the door, check it is secured
correctly, and align it with adjacent
furniture doors.
Tighten all the screws again.
To Next Page
