Checking the programmed water
hardness level
^
Switch the dishwasher off with the
On/Off button s.
^
Turn the programme selector to the
"12 o'clock" position.
^
Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button s.
Keep the Start/Stop button pressed in
for at least four seconds until the
"Start/Stop" indicator light comes on.
^ Turn the programme selector to the
"3 o'clock" position.
The "Wash/Rinse" programme
sequence indicator will flash for the
number of times which corresponds to
the water hardness level which has
been set (see chart).
^ Switch the dishwasher off with the
On/Off button s.
Before using for the first time
15
To Next Page
Loading...
Need help?
General
