Additional functions
Factory default setting
If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^
Switch the dishwasher off with the
On/Off button s.
^
Turn the programme selector to the
"12 o'clock" position.
^
Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on with the On/Off button
s.
Keep the Start/Stop button pressed in
for at least four seconds until the
Start/Stop indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
^
Turn the programme selector to the
"11 o'clock" position.
The "Wash/Rinse" indicator light will not
be lit up (indicating that at least one
setting has been altered from the
factory default settings).
^
Press the Start/Stop button.
The "Wash/Rinse" indicator will now
flash briefly at intervals (indicating that
all settings are now the factory default
ones).
^
Turn the programme selector to the
"9 o'clock" position.
^ Switch the dishwasher off with the
On/Off button s.
Operation
34
To Next Page
Loading...
Need help?
General
