Problem Possible cause Remedy
The Wash/Rinse,
Drying and End
indicator lights flash
simultaneously.
There may be a technical
fault.
–
Switch the dishwasher off
with the On/Off button s.
After a few seconds:
–
Switch the dishwasher
back on.
–
Turn the programme
selector to the required
programme.
–
Press the Start/Stop
button.
If the programme sequence
indicator lights flash again,
there is a technical fault.
– Call the Service
Department.
The drain pump works
even when the door is
open.
The Waterproof System
has reacted.
– Turn off the stopcock.
– Call the Service
Department.
Problem solving guide
41
To Next Page
Loading...
Need help?
General
