Additional functions
Factory default setting
If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^
Switch the dishwasher off using the
K button.
^
Turn the programme selector to the
"12 o'clock" position.
^
Press the Start/Stop button J / M in,
and whilst holding it in switch the
dishwasher on using the K button.
Keep the J / M button pressed in
until the J / M indicator light comes
on.
If this does not happen, start the
procedure from the beginning again.
^ Turn the programme selector to the
"11 o'clock" position.
The 8 programme sequence indicator
light will not come on.
^
Press the J / M button.
The 8 programme sequence indicator
will flash briefly once at intervals.
^
Turn the programme selector to the
"9 o'clock" position.
The 8 programme sequence indicator
light shows whether a setting other than
the factory default setting has been set.
–
If the 8 programme sequence
indicator light is flashing:
All settings are factory default
settings.
–
If the 8 programme sequence
indicator light is not lit up:
At least one setting has been altered
from the factory default setting.
^
To reset to the factory default
settings, press the J / M button.
^ Switch the dishwasher off using the
K button.
Operation
36
To Next Page
Loading...
