The dishwasher does not fill/drain.
Problem Possible cause Remedy
The 2 / 2 check
light flashes.
The stopcock is
closed.
Open the stopcock fully.
The dishwasher
stops during a
programme.
The 2 / 2 check
light flashes.
Before rectifying the problem you
must:
–
Switch the dishwasher off
using the K button.
Water intake is
restricted.
–
Open the stopcock fully.
–
Clean the water inlet filter. See
"Maintenance".
–
The water pressure at the
intake is lower than 30 kPa
(0.3 bar).
Seek professional advice.
Water outlet is
restricted, water
remains in the wash
cabinet at the end of
a programme.
– Clean the filter combination.
See "Cleaning and care".
– Clean the drain pump. See
"Maintenance".
– Clean the non-return valve.
See "Maintenance".
–
Remove any kink in the drain
hose.
Problem solving guide
43
To Next Page
Loading...
