Problem Possible cause Remedy
The 8, G and O
programme sequence
indicator lights flash
simultaneously.
There may be a technical
fault.
–
Clean the water inlet filter
and clean the drain pump
and non-return valve as
described in
"Maintenance". If this
does not resolve the
problem,
–
switch the dishwasher off
using the K button.
After a few seconds:
–
Switch the dishwasher
on.
–
Turn the programme
selector to the required
programme.
– Press the J / M button.
If the programme sequence
indicator lights flash again,
there is a technical fault.
– Call the Service
Department.
The drain pump works
even when the door is
open.
The Waterproof system
has reacted.
– Close the stopcock.
–
Call the Service
Department.
Problem solving guide
42
To Next Page
Loading...
