Waterproof system
All Miele dishwashers have a safety
valve located on the incoming water
line and a sealed underside with a
water sensor.
If a fault occurs, the water intake is
stopped and the drain pump is
activated. Water damage, if any, is
minimized.
Providing the dishwasher was installed
correctly by a Miele technician, the
waterproof system will protect you from
water damage throughout the lifetime of
the machine.
Connection to the water
supply
,
Installation, repairs and other
work by unqualified persons could
be dangerous.
,
Do not drink water from the
dishwasher!
–
The dishwasher can heat its own
water to the temperature required by
the wash program. This allows for
connection of the machine to either a
hot (max. 140°F / 60°C) or cold water
source.
For lowest energy consumption and
fastest possible wash times connect
the dishwasher to a hot water
source. All programs use hot water in
the rinse cycles.
– The inlet hose is approximately 5 ft.
(1.5m) long.
–
The water inlet hose comes
equipped with a 3/4" female hose
thread connector. This can be
directly connected to a water supply
with 3/4" MHT (male hose thread
ends).
If not connected directly to a water
supply valve, an appropriate
adapter (not required) is required.
Plumbing
53
To Next Page
Loading...
