Setting the rinse aid dosage
The rinse aid dosage can be set at
levels between 0 and 6 ml. The factory
setting is 3 ml of rinse aid. This is just a
recommendation.
If the dishes appear spotty:
^
Use a higher setting.
If the dishes appear cloudy or streaky:
^
Use a lower setting.
^
Press the K button to turn the
dishwasher off.
^
Hold down the Program button and
simultaneously turn the dishwasher
on using the K button.
Keep the Program button pressed for
at least four seconds until the lower
right program indicator lights up.
If it does not come on, start over.
^
Press the Turbo button three times.
The Turbo indicator light flashes 3 times
at short intervals.
The time display shows the flashing
sequence p3.
The set value is shown in the time
display after the P.
^ Select the desired dosage with the
Program button.
Every touch of the button increases
the level.
The setting is saved immediately.
^
Press the K button to turn the
dishwasher off.
Before using for the first time
18
To Next Page
Loading...
