Factory defaults
If you have changed any settings, you
can reset them to the factory defaults.
^
Open the door.
^
Press the K button to turn the
dishwasher off.
^
Press and hold the Program button
and simultaneously turn the
dishwasher on using the K button.
Keep the Program button pressed for
at least four seconds until the lower
right program indicator lights up.
If it does not come on, start over.
^ Press the Turbo button 12 times.
The Turbo indicator shows 1 long flash
and 2 short flashes in intervals.
The flashing in the time display shows
whether a setting is different from the
default setting.
–
"p1": all values are set to the default
settings.
–
"p0": at least one setting has been
changed.
^
Press the Program button to reset the
dishwasher to the factory defaults.
The setting is immediately saved.
^
Press the K button to turn the
dishwasher off.
Additional options
41
To Next Page
Loading...
