Using for the first time
23
Displaying and setting the water
hardness
Open the door.
Switch the dishwasher off with the
button, if it is switched on.
Press the button in and, while
holding it in, switch the dishwasher
on using the button.
Keep the button pressed in for at
least 4seconds until the indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the programme selection
button 2 times.
The top left programme indicator light
will flash rapidly 2 times at intervals.
The value set is shown as a figure after
in the time display.
will start flashing in the display.
A water hardness of 2.5mmol/l (14°dH
– German scale) is set.
Use the button to set the water
hardness level for your area.
The setting increases each time you
press the button. When the highest
value is reached, the setting starts
again from the beginning.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
To Next Page
Loading...
Need help?
General
