Miele G 5481 - Signal Tones

Programme options
57
Signal tones
A sequence of signal tones will sound
at the end of the programme or if there
is a fault.
The signal tones at the end of a
programme and the alarm tone in the
event of a fault will sound 4times at
intervals with a short pause between
each set.
The signal tones are switched off as
standard.
You can switch on the signal tones that
sound at the end of a programme if you
wish. The alarm tone that sounds in the
event of a fault is always switched on.
 Open the door.
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the button in and, while
holding it in, switch the dishwasher
on using the button.
Keep the button pressed in for at
least 4seconds until the indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
 Press the programme selection
button 4 times.
The top left programme indicator light
will flash rapidly 4 times at intervals.
The flashing sequence in the time
display indicates whether the signal
tones at the end of the programme are
activated or deactivated:
-  : Signal tones are activated
-  : Signal tones are deactivated
 Press the button to change the
setting.
The setting is now stored in memory.
 Switch the dishwasher off with the
button.