EasyManuals Logo

Miele G 5775 User Manual

Miele G 5775
159 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #126 background imageLoading...
Page #126 background image
Technical Information
126
G 5xxx
3.8 Fault Code Summary
Note: Not all fault codes apply to all model numbers.
Fault code Possible fault
F00
No fault registered
F01 (see Section 080-3.9)
Water/heating NTC or leads short-circuited
F02 (see Section 080-3.10)
Water/heating NTC or leads open-circuited
F11 (see Section 080-3.11)
Drainage fault
F12 (see Section 080-3.12)
Water intake fault at start of step
F13 (see Section 080-3.13)
Water intake fault at end of step
F14 (see Section 080-3.14)
Water intake fault: Heater pressure switch
F15 (see Section 080-3.15)
Water intake fault: Hot water
F18 (see Section 080-3.16)
Flow meter stationary state monitor
F19 (see Section 080-3.17)
Flow meter stiff and not turning freely
F24 (see Section 080-3.18)
Heater relay contact
F25 (see Section 080-3.19)
Target temperature fault
F26 (see Section 080-3.20)
Boiling protection
F32 (see Section 080-3.21)
Door lock does not close
F33 (see Section 080-3.22)
Door lock does not open
F36 (see Section 080-3.23)
Door lock switch defective
F40 (see Section 080-3.24)
Electronic fault
F42 (see Section 080-3.25)
Line frequency registration fault
F47 (see Section 080-3.26)
Faulty electronic interface (between BAE & SLT)
F51 (see Section 080-3.27)
Heater pressure switch
F52 (see Section 080-3.28)
Heater pressure switch has reset during heating
F63 (see Section 080-3.29)
Slide shutter fault
F67 (see Section 080-3.30)
Circulation pump speed too low
F68 (see Section 080-3.31)
Circulation pump operating after switch-off
F69 (see Section 080-3.32)
Circulation pump blocked
F70 (see Section 080-3.33)
Float switch fault
F78 (see Section 080-3.34)
Circulation pump fault
F79 (see Section 080-3.35)
Circulation pump communication fault
F84 (see Section 080-3.36)
Slide shutter positioning fault
F85 (see Section 080-3.37)
Slide shutter signal change fault
F86 (see Section 080-3.38)
Lid contact - salt
F88 (see Section 080-3.39)
Turbidity sensor fault
F91 (see Section 080-3.40)
Load size registration inactive
Table 080-6: Fault Code Summary

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miele G 5775 and is the answer not in the manual?

Miele G 5775 Specifications

General IconGeneral
BrandMiele
ModelG 5775
CategoryDishwasher
LanguageEnglish

Related product manuals