Drying fan running time
During the drying phase, as long as the
door of the dishwasher remains closed,
moist air is expelled through the ventila
-
tion outlet for the drying fan. The drying
fan running time can be increased to
avoid the risk of damage to a worktop
fitted above the dishwasher. If this op
-
tion is selected, the fan will continue to
run for approx. 14 minutes after the end
of a programme.
Activating and deactivating in
-
creased drying fan running time:
^ Switch the dishwasher off using the
"On/Off" button.
^ Turn the programme selector to the
"Stop" position.
^ Press the "Top Solo" button in and
whilst holding it in
switch the dish-
washer on using the "On/Off" button.
Release the "Top Solo" button within
two seconds.
The "Salt" indicator light will start flash
-
ing
Note:
If a different indicator light comes on or
flashes, the process must be repeated.
Exception:
The "Rinse aid" indicator light will come
on if you have not yet added rinse aid
or if rinse aid needs replenishing.
^
Turn the programme selector to the
"9 o’clock" position.
–
If the "Top Solo" indicator light does
not come on: the fan running time is
not increased,
–
If the "Top Solo" indicator light does
come on:
the fan running time is increased.
^
Press the "Top Solo" button to change
the setting.
Depending on the previous setting the
"Top Solo" indicator light will either
come on or go out.
^ Turn the programme selector to the
"Stop" position.
^ Switch the dishwasher off using the
"On/Off" button.
The change is now stored in memory.
Operating the dishwasher
41
To Next Page
Loading...
