Screw feet
^ Use a TORX T20 screwdriver to
adjust the rear screw feet to the
required height.
Higher = turn clockwise
Lower = turn anti-clockwise
Several turns are needed to adjust 1
mm in height.
^
Adjust the front screw feet manually
or with a flat blade screwdriver.
Screw the feet out until the seal on
the dishwasher is right up against
the underside of the worktop, to
which it will be screwed later. Ensure
that the dishwasher stands level.
Installing built-under "U" model dishwashers
26
To Next Page
Loading...
