4.Matching the facia panel to
the height of adjacent drawer
fronts
The facia panel can be aligned with the
drawer fronts by adjusting the spacer
bars.
^ Using an 8 mm socket spanner turn
clockwise or anti-clockwise until the
required height is reached.
If necessary some or all spacer bars
can be removed.
^
Press out the spacer bars from the
fitting slits in the facia panel.
Adjustment range:
from 112 mm: Facia panel
without spacer bars
to 145 mm: Facia panel with
up to 4 spacer bars
to 154 mm: when using an extra
(fifth) spacer bar
(special accessory at
extra cost)
After adjustment cut off any
protruding lengths of screws.
Installing integrated "i" Dishwashers
13
To Next Page
Loading...
